creo7 Drawing Setup option documentation for: dim_trail_zero_max_places
dim_trail_zero_max_places
Sets the maximum number of decimal places for dimensions and dimension tolerances when trailing zeros are used to attain the maximum number
of decimal places defined by the default_dec_places configuration option. Specify a value that is less than the specified number of decimal places for dimensions to
control the number of trailing zeros.
Default and Available Settings:
same_as_dim
| This Detail option does not
affect decimal places if the value specified for the lead_trail_zeros Detail option prevents trailing zeros from being displayed.
This Detail option affects the display of all dimensions in a drawing. You cannot
individually control the number of decimal places for dimensions with trailing zeros.
This Detail option does not affect angular dimensions displayed in the degree, minute, and
second format.
|
Consider the following example:
1. Specify the value 2 for the default_dec_places configuration option.
2. Specify the value same_as_dim for dim_trail_zero_max_places.
3. Specify the value both for lead_trail_zeros.
4. Click > and type the value 6. Trailing zeros are added for dimensions whose values do not extend upto 6 decimal places.
Such dimensions are identified by an arrow as shown in the following figure:
In this example, if you change the value of dim_trail_zero_max_places to 3, trailing zeros are added for all
dimensions with values less than 3 decimal places. Such dimensions are identified by an arrow as shown in the following figure: