www_export_geometry_as

jpg_vrml * , vrml , cgm , jpg , cgm_vrml , cgm_jpg , all

Specifies the format of the output as one of the following values:

jpg_vrml - Specifies JPG and VRML as the formats of the output data.

vrml - Specifies VRML as the format of the output data.

cgm - Specifies CGM and VRML as the formats of the output data. Sets up the site to only show CGM.

jpg - Specifies JPG and VRML as the formats of the output data. Sets up the site to only show JPG.

cgm_vrml - Specifies CGM and VRML as the formats of the output data.

cgm_jpg - Specifies CGM and JPG as the formats of the output data.

all - Specifies CGM, JPG, and VRML as the formats of the output data.

> Creating and modifying driven dimensions (i.e. dimensions created in the drawing)

Creation and modification of an assembly explode state

Creation and regeneration of a cross-section.

The revision number of the design does increase after the model is saved.

Modifying the attachment of a set datum. This applies to both driven and driving dimensions.

The following commands will be allowed when draw_models_read_only is set to cosmetic_only . These commands do not cause iteration of the model:

Modifying layers and layer display

Modifying the line style of a three dimensional solid model.

Any changes that are made to the part or assembly outside of drawing mode are not prevented by this configuration option.

Moving the position of a set datum tag

Extending or trimming a model axis

Switching a detail item from one view to another

Creating and modifying a geometric tolerance that is created in the drawing and only references the drawing

Creating and modifying two dimensional notes in a drawing

Creating and modifying two dimensional entities in a drawing