www.creosite.com© O. Corten

creo6 config.pro option documentation for: REVERSE_SPIRAL_FINISH_TYPE            


reverse_spiral_finish_type

0 , 1 , 2
This configuration option is applicable to the Finishing steps when the FINISH_OPTION parameter is set to SHALLOW_CUTS or COMBINED_CUTS and SHALLOW_AREA_SCAN parameter is set to SPIRAL_SCAN .
The configuration option accepts three values: 1, 2, and the default value 0. Any other value is treated as a default value.
For the default value 0, one of the following options set for the SPIRAL_SCAN_DIRECTION parameter is considered.
INSIDE_OUT - Toolpath starts from inside and follows the outer boundary.
OUTSIDE_IN - Toolpath starts from outside and follows the outer boundary.
For value 1: Regardless of the option set for SPIRAL_SCAN_DIRECTION , the toolpath starts from inside and follows the outer boundary.
For value 2: Regardless of the option set for SPIRAL_SCAN_DIRECTION , the toolpath starts from inside and follows the constant load strategy.
1. Toolpath for value 1
2. Toolpath for value 2