minimum_angle_dimension

Specifies the minimum angle value at which selected dimension references are not considered parallel.

Default and Available settings:

The default value changes based on the Creo Parametric version in which the drawing is created.

If you open a drawing created in Creo Parametric 4.0 M070 and earlier, the default value is follow_config, meaning the default value is as specified in the configuration option minimum_angle_dimension.

If you open a drawing created in Creo Parametric 4.0 M080 and later, the default value is 1.

You can specify a different value.

For example, you can specify 4 as the value for this Detail option. If the angular value between the references is 3, a linear dimension is created between the references. If the angular value between the references is 5, an angular dimension is created between the references.