www.creosite.com | © O. Corten |
use_internal, replace_with_external
controls the embedding of customized hole files in a part model.
use_internaloenables the hole tool to refer hole files that are embedded into a part model and ignore external hole files.
replace_with_externalo enables the hole tool to refer external hole files available on your local disk and ignore embedded hole files.
be careful while setting this value. if you set this value, you can observe the following changes in a part model after you redefine a hole, modify the screw size, revert to the previous screw size, and then save the model:
if an external hole file has the same thread series name as the embedded hole file, then the hole tool replaces an embedded hole file, by copying the external hole file into a part model.
if an external hole file has a thread series name that is different from that of the embedded hole file, then the hole tool uses values from the external hole file without embedding the external hole file.